Projector Mounting Instructions – Ace Indoor Golf Skip to content

Projector Mounting Instructions

To install your projector, you will need the following items:

  • 1-1/2" Steel Pipe with Threads, usually 8" long
  • 1-1/2" Steel Pipe Floor Flange
  • 2 - 4 Lag Screws, 1/4" x 3" minimum
  • Phillips Head Screwdriver
  • Drill with Socket Head Attachment

Step 1: Unbox Projector and Mount.

all golf simulator projector parts

Step 2: Flip Projector over and make sure the legs are screwed tight to the body.

Step 3: On each arm, squeeze clips and push towards the long end. This will release the mounting bracket (acorn looking piece). Make sure to unscrew the bracket as far as you can without removing the nut.

demonstration of golf simulator projector arms

Step 4: Locate M4x10mm screw. These are appropriate for most projectors, but may not be for yours, please make sure you verify what works best for you.

bag of golf simulator projector screws

Step 5: Attach Mounting Brackets to the bottom of projector. All projectors need 3 mounting brackets, some will accommodate 4. More is always better.

bottom of golf simulator projector

close up photo of golf simulator projector bottom

Step 6: Attach arms and pull tabs back towards the short end.

demonstration of attaching arms to golf simulator projector

Step 7: Attach plate with pegs upwards and 5 holes facing the projector lens.

golf simulator projector plate

Step 8: Locate Allen nuts and large hex key.

golf simulator projector hex keys

Step 9: Attach plate with bolts in the center of the corners on the plate (3 will usually line up). Attach Allen nuts to bolts. The goal is to center the plate / mount on the projector, or get as close to center as possible.

demonstration attaching plate to golf simulator projector

Step 10: Tighten (but don't over-tighten) Allen nuts.

Step 11: Attach the cover plate - it just sits on.

golf simulator projector cover plate

Step 12: Hang flange on the ceiling. Make sure to attach it to your rafters / joists.

Step 13: Screw in your pipe to the flange. Get it as tight as you can.

screwing pipe into flange for golf simulator projector

Step 14: Screw mounting mechanism to the pipe. Tighten as much as possible, keeping the lock on the left side of the projector.

screwing mounting mechanism into pipe for golf simulator projector

Step 15: Holding the projector and mount to the mechanism, close the lever to lock into place.

closing lever on golf simulator projector

Step 16: Attach cables and turn projector on.

You may need to make some adjustments to your projector.

This screw on the side of the projector adjusts vertically.

demonstrating the correct screw on golf simulator projector

This screw on the front of the projector adjusts horizontally.

demonstrating second screw on golf simulator projector